Work has been so busy that the working on the car has had to, reluctantly, wait. Anyway, the New Year should be a little quieter and I’ve already started working on a few bits and pieces. At the last MOT the hazard lights weren’t working. I’m 95% sure that it’s an issue with the switch. …
Author Archives: Tim Lees
Been ages
Hi All, I know it’s been ages since I last posted! Work has been busy and I’ve just been out enjoying the car… really need to spend some time updating the blog because I’ve finished a load of jobs. When I get a spare few minutes I will!
Progress, progress, progress
It’s been a really productive few days helped by some unseasonably warm weather (back to cold now!) and the easing of the lockdown restrictions meaning I’m comfortable in visiting the garage. The carbs are now back on the car with the new fuel lines cut to size. Somehow I managed to lose a top cover …
Distracting body(work)
18/03/2021: Partly as a distraction from the carbs (which is taking me far too long) I couldn’t help but revisit the improvements I was making to the nose cone. The foam insert that the hood rests on was pretty tatty and falling away. I’ve bought new and have cut new pieces. It also turned out …
Head scratcher….
So this is a puzzling one… I’ve fully assembled both carbs. The fuel pump is sat considerably lower on the carb with the new parts. I’ve compared the fuel pumps and they are identical. The difference in height can only come from the alignment of the cam. So it’s either the shape of the cam …
Back on track…
Yesterday afternoon I very carefully cut the new split pin down to size, bevelled the end and shaped it a little with the pliers. With plenty of WD-40, trial alignment and I’ll admit holding of breath (!) I gently tapped it into it’s new home with success! Such a relief! The actuating cam seems to …
Oops…
Things were going so well with the carb refurb and then I made a series of really silly and compounding mistakes. One carb is fully assembled and when working on the second, without realising it, I put the spindle in 180 degrees out from how it should have been installed. Then when attaching the fuel …
Carb re-assembly
Most of the parts have now arrived and the carburettor reassemble is underway! I’ve updated the carb page with the progress. I was planning on buying some shot blasting gear but unfortunately my daily drivers was vandalised at some point between the 30th December and early afternoon on New Year’s day. I suspect this was …
Brooklands Autosolo…
So I had the SuperSix out at the FDMC Brooklands autosolo at the weekend. Mixed fortunes. The weather was rubbish but I seem to drive faster the wetter it is! Here’s a link to the first three runs: Quite pleased how hard I pushed on the third and final run. I was placed 3rd in …
MOT Pass!
Last week was the first MOT pass! A bit close on the emissions and the hazards developed a fault on the way to the test centre but really pleased. Next weekend is the last autosolo (at Brooklands) and today I did 300 miles to the south coast and back. After this is time to put …
Tim’s Tiger blog 